The total pressure generated by the hydraulic machine is often used for forging and stamping. Forging hydraulic machines are divided into two types: mold forging hydraulic and free forging water pressure machines. The mold forging water pressure machines should be used with molds, and free forging water pressure machines do not use molds. The first 10,000 -ton hydrocarbon made by my country is a free forging hydraulic machine.

The section of the penetrating groove consists of two levels of straight edges and two arcs. The bending machine workbench, which is a practical new type of deflection compensation, uses the deflection compensation device to overcome the effects of sliding block deformation on the workpiece on the quality of the workpiece, ensuring the good straight lines and bending angles of the processing workpiece. CNC copper row bus processing machine manufacturer

Each class adds lubricating oil to each unit motion component. When changing the mold, it must be stopped to avoid danger. When operating, take the workpiece to wait for the slider to be careful. It should be regularly checking the sharpness of the blade and the brake blade of the blade.

The position of the old -fashioned line disk of the old -fashioned lines of the CNC busbar cutting punching and bending machine is parallel to the ground, and a single or more wire plate is put into the IML iron rod to put it on the line. When the number of winding turns remembers the number, the main axis of the automatic bus machine drives the wire mold from the rated speed to zero in an instant. Due to the inertia of the wire plate, you cannot immediately quenched, and the wire disk continues to release the line. If the wire disk is full, the more threads are easy to overlook the line disk, and even wrapped in the iron rod of the fixed line disk. Broken, strict roads affect the quality FI of the motor winding, and also affect production efficiency. In addition, the old -fashioned automatic bus machine does not have a soft start and soft parking. The automatic bus machine not only has precision mechanical components, but also a powerful electrical control system. The debugging method is much more complex and fine than other electrical processing equipment. This article lists the following points of the function and common debugging methods of the automatic bus machine:

Because loosening will produce a very obvious 1X base frequency peak. There are two types of loosening in actual: rotation loose and non -rotating loose. Bearing wear may cause rotation loosening. This fault first measures the signs of bearing wear during detection, and then the bearings can be loose. When the sliding bearing is a problem with the gap, its spectrum shows a very similar feature to rotating looseness: a strong 1x harmonic appears. In most cases, the vibration in the vertical direction is higher than the vibration in the horizontal direction. For the non -rotating loosening of the structure loose (elastic foundation), the loosening between the machine and the foundation will increase the 1x vibration in the minimum rigid direction, usually in the horizontal direction, and also depends on the installation and layout of the machine.

In short, the step -step -steps of the bus is to determine the real causes and faults as soon as possible according to the fault phenomenon. These fault treatment methods are not strictly used in actual use. It may also be carried out at the same time. Its effect depends on the experience of maintenance technicians and its depth of understanding and grasp of system principles and structures. This is not only the quality that the maintenance personnel must have, but at the same time, the maintenance personnel have made high requirements. It requires the CNC parent maintenance personnel to be familiar with the structure and design ideas of the parent machine. Quickly find the cause of the fault and judge the fault position. In addition, in order to perform on -site surveying and mapping for certain circuits and parts during maintenance, as a senior maintenance personnel, they should also have a certain ability to draw engineering drawings. CNC copper row bus processing machine manufacturer

The second trick: It is necessary to adhere to the working current of the bus motor motor is large. Because the electric motor is too large, the voltage is too low or the mechanical card stagnation of the motor will cause the motor to forward it. Because this, the motor is at work, you should pay attention to often often. Check whether the operation of the transmission device is active and reliable; whether the concentricity of the shaft device is standardized; the activity of the gear transmission, etc. If you find that there is a stagnant appearance, you should immediately stop the shortcomings and then work.