Any product that uses electricity, with the passage of time of the product, and the aging of the power cord in the process of use, can have the ability to leak electricity. Although the leakage of the busbar bender is rare, it is still important to be careful. After all, there is no trivial matter, and the actual leakage is a major event. The following are some of the methods to prevent leakage for us. During the use of the power cord, the rubber skin on the outside of the power cord is broken due to kneading or pulling. This is the most direct cause of leakage. The best way is to not throw the power cord on the ground at will and prevent the power cord from being damaged. To damage. If the power cord has broken and the inner electric wire can be seen, replace the power cord in time. Whether the bus processing machine is working or during maintenance, it is necessary to adhere to the dryness of the bus processing machine and the surrounding environment, especially the power cord, not to touch water, so it is easy to cause leakage symptoms, and a boring environment can protect against leakage. Appearance can prevent rust from appearing to a certain extent, so why not do it.

When the machine stops operating, it is probably a good thing to close the machine bus processing machine in time and unplug the power cord. This will not only prevent leakage, but also save a lot of electricity. It is a beautiful thing. Everyone knows that any machine is the most comfortable and best to use when it is just bought. After using it for a while, it will feel slow, the operation is not so delicate, and the goods handled are not so smooth. The same is true for the copper bending machine. When I first bought it, I found it a little easy to use. The more I used it, the more I felt that the feeling of the machine was not so right, but this is not the question of the machine itself. How to make the busbar processing machine always adhere to the best operating conditions? Let's briefly analyze it for us today. According to what we know about the application status of the busbar processing machine, most customers do not even have the most basic maintenance. Let it be developed. When the application reaches a certain time, it will naturally show a non-optimal status. The first thing we need to focus on here is that we must regularly protect and maintain the bus processing machine. It is more convenient and more economical to insist on doing something more often than to send it to repair once a problem.

Next, after we have a deeper understanding of the bus processing machine, another discovery is that the bus processing machine has always been in the process of overloading. After the bus processing machine is used for a long time, it must be let it rest. Check the wear and other conditions of each component, make a brief adjustment and then let it enter the work position, and continue high-pressure work, even if it is a machine, it can't stand up. A more serious point is that workers start to operate at will without reading the operating instructions. This is expressly prohibited and has been emphasized repeatedly. The faulty operation sequence and the faulty operation method are facing the abyss, whether it is the bus processing machine or the operation of the machine itself. Buyers must provide in-depth counseling on the situation. Doing every detail well can make the service life of the copper cutting machine  a little longer and the working condition better. In order to maintain the best use of the bus processing machine, you should take action on the points mentioned above. The two most important features of the portable bus processing machine: It can be carried and used very conveniently. The use of portable bus processing machine: The portable bus processing machine is still somewhat different from the general bus processing machine. The portable bus processing machine is more suitable for mobile work. Because of its convenience and carrying this feature, it has the speed that the bus processing machine does not have. In some urgent factories, such as rescue sites, blasting sites, and emergency sites where there are strict requirements for work, it is difficult for all machinery to enter. At this time, portable bus processing machines can show their power. Solve this problem easily.