Keep and Share logo     Log In  |  Mobile View  |  Help  
 
Visiting
 
Select a Color
   
 
Relevant requirements of safety operation regulations for CNC bus processing machines

Three-station busbar processing machine, lubricate each moving part before processing, once in the morning and once in the afternoon. When changing the mold, be sure to turn off the main power of the equipment to avoid personal injury caused by misoperation The cutting process uses the observation holes of the upper and lower blades to observe the actual cutting position. Place the busbar on the worktable, use the ruler slider to block the material, determine the cutting size, and then use the pressing handwheel to press the busbar. Prevent the material from lifting up and damaging the mold. When the quality of the copper  cutting machine port is not good, please check the mold gap (0.25~0.35mm range) of the upper and lower blades and whether the mold is worn. Turn on the power switch of the equipment and step on the foot switch of the unit The oil pump starts. Depress the foot switch, the upper scissors will move forward, release the foot switch during the forwarding process, and the upper scissors will stop running. Step on the foot switch again, the upper scissors will continue to move forward, when the limit switch is touched , The upper scissors will automatically return to the top dead center. When the upper scissors need to return during the process, when the corresponding manual back button is pressed, the upper scissors will return, and when the back button is released, the upper scissors will stop backing.

 

Punching, in the process of punching, should ensure that the processed materials remain level. Matching molds must be used when punching. Do not mix upper and lower molds with different inner diameters. When processing long round holes, make sure that the direction of the upper and lower molds is the same, otherwise the mold will be damaged. Turn on the power switch of the equipment and step on the foot switch to start the unit oil pump. Step on the foot switch, the punch will move forward, release the foot switch during the forward process, the punch will stop running, step on the foot switch again, the punch will continue to move forward, when the limit switch is touched, the punch will move forward. It will automatically return to the top dead center. When the punch needs to return during the process, press the corresponding manual back button,busbar bender the punch will go back, release the back button, the punch will stop backing. Mold replacement must be kept clean; frequent inspections are required during the punching operation, and the upper and lower molds must be fixed with bolts to prevent loosening, causing offset and damaging the mold.

 

When bending, the appropriate mold should be selected according to the thickness and width of the material. The bending die is fixed on the bending die seat, and the bending die is placed on the punch according to the thickness of the row. Turn on the power switch and step on the foot switch to start the bending unit oil pump. Depress the foot switch of the bending unit, the movable mold will move forward, release the foot switch during the forwarding process, the movable mold stops advancing, step on the foot switch again, the movable mold will continue to advance, and the movable mold needs to move back during the process.copper bending machine Press the back button, the movable mold will return to the desired position, release the back button, the movable mold will stop backing.


Creation date: Mar 13, 2021 12:47am     Last modified date: Mar 13, 2021 12:53am   Last visit date: Dec 11, 2024 7:23am
    Report Objectionable Content