To make sure your calendar, event reminders, and other features are always
correct, please tell us your time zone (and other details) using the
drop-down menus below:
Set Date/Time format:
In 12 Hour format the hours will be displayed as 1 through 12 with “a.m.” and “p.m.”
displayed after the time (ex. 1:00p.m.). In 24 hour format the hours will be displayed as 00 through 23 (ex. 13:00).
You can always change your time zone by going to your Account Settings.
Use the dropdown menu to view the events in another time zone. The primary time zone will be displayed in parentheses.
Use the dropdown menu to view the events in another time zone. The primary time zone will be displayed in parentheses.
Check the items that you want displayed. Uncheck all to hide the section.
Calendars
Files
Addresses
To Dos
Discussions
Photos
Bookmarks
The “Switch Navigator” button will no longer be available after February 14, 2017.
Please learn more about how to use the new Navigator by clicking this link.
Nissan ECU reflash update procedure using Consult III Plus
The Nissan Consult III Plus scan tool is required to complete the process of flashing/reprogramming Nissan ECUs. This process works for any computer in any Nissan vehicle and is the same process if you are using the factory tool (Nissan Consult) or a J2534 tool.
A Consult3+ clone can be used to flash ECUs but will only work on pre 2016 Nissans. For newer Nissans the reflash file must be purchased for the Nissan website and is an additional purchase to the Nissan subscription purchase that you must also make . Some vehicles require you to email Nissan to have the file sent to you to purchase the file but require subscription purchase Nissan Consult III+ ECU Reflash/Reprogramming Update Procedure
Model example: Nissan Maxima 2016
Reprogram ECU Throttle valve closed position learning Idle Air Volume learning Accelerator Pedal Closed position learning Confirmation Start up Engine Erase DTCs Completed
Detail:
Select vehicle information, Go to Measurement Mode
Read Precaution and confirm
Read VIN and confirm Cumminicating with vehicle
Select Engine system->Reprogramming
Save operation log Read and confirm operation procedure
Check vehicle detail information and confirm
Confirm vehicle condition. Remove the terminal caps of the battery and connect battery charger to battery. Adjust the battery charger output so that the vehicle voltage is between 12.0V and 13.5V.
Confirm the RESULT is ok and confirm vehicle conditions listed on the interface
Transfer data among computer, Nissan Consult 3 plus and vehicle
Reprogramming is completed.
Perform throttle valve closed position learning
Fully release the accelerator pedal. Turn ignition ON and turn off. Then count download of 10 seconds starts.
Make sure throttle value moves during count down of 10 seconds by confirming the operating sound.
Turn Power switch/ignition SW to ON position.
Perform Idle Air Volume learning
Perform Accelerator Pedal Closed position learning Turn ignition switch to OFF position and hold it for 10 seconds or more
Turn ignition switch to ON position and hold it for 2 seconds or more
Repeat the procedure once or twice
Turn ignition switch to OFF position
Confirmation Start up Engine Confirm the engine keeps starts and idling normally. Erase DTCs
Attach this document to an event, task, or address
You can attach a link to this document to an event in your Calendar, a task in your To Do list or an Address. Check the boxes below for the data you want to
bring into the event’s or task’s description, and then click “Select text to copy” to have the next event or task you create or edit have the document text and link.
