The topic I want to share with you today is the multi -functional hydraulic busbar bending machine. What brand is good for the following explanations. You can have more understanding of this aspect!

The cross -section shape of the hard bus is rectangular, groove and tube. The rectangular bus is large, with high material utilization rate, and has a good anti -bending strength when bending, but the skin combines effect is large. In 4000A and below house distribution devices. The groove -shaped parent line has a small skin collection effect, good cooling conditions, and high mechanical strength. It is often used in a power distribution device with 35kV and below and continuous working current at 4000A -8000A. The curvature radius of the tube -shaped bus is large, the material conductivity, heat dissipation, bending strength and rigidity are good, the skin combines effect is small, it can be used for large current bus above 8000A, or can be used for 220kV and above house power distribution devices as long as the length Crossing the hard bus.

Tighten gently; under the state of stopping, use the meter to adjust the gap between the upper and lower blades. What brand of processing machine is good

The occurrence of failure or absence of faults is divided into systemic faults and random failures. Systemic failure refers to the determined failure that will occur if certain conditions are met; and random failure refers to the occasional failure under the same conditions. This type of failure is difficult to analyze. It is usually more than the mechanical structure of the machine tools. Local loosening dislocation, some electrical workpiece characteristics drift or reduction of reliability, and the internal temperature of the electrical device is too high. This type of failure Dalin CNC analysis needs to be excluded repeatedly and comprehensive judgment.

The analysis process of the bus electrical failure is the process of exclusion of the fault. Therefore, some commonly used elimination methods of the bus electrical failure. Shandong Dalin Machinery will take a look:

What brand of multifunctional hydraulic parent line processing machine is good. The above information is the relevant knowledge of the fault processing method of the parent machine that is described by everyone. Through the content of the information shared above, everyone must have a corresponding understanding? If you want to learn more about this, please consult the editor to bring you better and more thoughtful services.

The process of investigation, analysis and diagnosis of CNC machine tool electrical systems is the process of failure of the failure. Once the cause is found, the fault is almost equal to exclusion. Therefore, the method of fault analysis diagnosis becomes very important. The common diagnostic methods of electrical failure are listed below.

The role of the decision of the hydraulic bending machine makes the shape and size of the embryo form a difference. The materials used by many hydraulic bending machine molds on the market are usually used. The quality of the materials, the quality of the use of the materials of the utilities is okay. What brand of multifunctional hydraulic bus machining machine is good

The dynamic characteristics of machine tools have become poor, the quality of workpieces has decreased, and the machine tool is vibrated even at a certain speed. A large one of them may be caused by excessive gaps between the mechanical transmission system or even severe wear, or inadequate rail lubrication or even wear; for the electrical control system, it may be the best matching The state should be re -adjusted after the mechanical failure is basically excluded.