The role of a fully automatic copper row bending machine (what is the price of the Shanxi portable copper row processing machine)

However, the flat bus is very different from the circular bus. The difference is that the same machine can only apply to different line diameters only after replacing different specifications. Products, and also have a certain scope of clamping.

The action method of fully automatic copper row busbar machine: Take off the switching power transformer, use water -free alcohol and medical cotton balls to thoroughly clean the switch power transformer pins, outer surface, and print circuit board. If the insulation is damaged, the damage can be wrapped with a polyester tape.

Turn off the power switch of the workshop, pay special attention: if there is an abnormal phenomenon when the bus processing machine work, you should immediately press the emergency stop button and check and repair it after the downtime, pay attention to personal safety!

The storage line ring, also known as the steel ring, is the most important component on the nose used to complete the storage line and winding. The quality of its quality directly affects the service life, indirect cost, and winding products of the product. quality.

The scissors are used for processing, cutting, pressing, slotting, grooved, cutting, diagonal angle, diagonal angle, etc. with thickness of thickness ≤15mm, width ≤200mm, and length ≤6000mm. ) Automatic processing of the homeline. Pole pitch accuracy ≤ ± 0.1mm, positioning accuracy ≤ ± 0.05mm, and repeated positioning accuracy ≤ ± 0.03mm. The role of fully automatic copper row bending machine

Enter the wire: transport cables and peel the line header. When peeling the short -term, the lines are peeled and the tails are peeled (the line length is less than 50mm). In addition to the peeling line when peeling, it also has the function of peeling in the middle.

When the full -automatic copper row bending machine, when the bus is clean, the temperature of the oil should not exceed 20 degrees Celsius. If the light fire is used directly, you should pay attention to avoid burning the oil. The bearings should be hung in the oil pan.

Bending angle CNC, making it difficult to master the bending angle is very easy and convenient, with high accuracy. With memory function, the data of the processing workpiece can be transferred at any time. It is a prominent advantage that traditional methods cannot compare. The touch screen has the calculation function of the workpiece graphical angle (that is, the length of the graphical edge, and automatically generate the bending angle). By replacing the mold, the flowing stream can be flattened, standing, etc. can be made.