Step on the bending unit's pedal switch or the corresponding buttons, the slider will move forward until the switch is touched before, and return to the original state. If the slider moves forward It will stop. At this time, if you step on the foot switch or the corresponding button, the slider will continue to move forward; if you press the "back" button on the bending unit panel, the slider will stop back to the original state.

Keep the oil clean and the oil circuit is unobstructed. Each class add lubricating oil to each unit motion component. Electric and hydraulic components must ensure flexible movements and positions. After the switch is turned off, the power supply must be disconnected. This is very important, and it is the most easily overlooked. If the power is not cut off, if there is a problem, it will be lost.

Plan formulate. The parent line processing machine combined with three processing stations should be reasonable to talk about the layout of the three station stations and the height of the workbench. It is convenient and simple to use. It can work at the same time and does not interfere with each other. Different specifications of copper and aluminum parent lines, the mold design is practical, durable, 2/9 simple, good interchangeability, replacement convenience ⑶, three sets of independent hydraulic systems, users can start a single processing station according to the use situation to reduce energy Consumption.

Multifunctional copper row production manufacturers often check whether the three -phase current of the parent processing motor is balanced. The three -phase induction motor, the difference between the three -phase current, the uniform value of the current and the other two -phase current is not allowed to exceed 10 %, so that the ability to ensure the safe operation of the motor. If it exceeds that the motor is faulty, it should be checked that it should be clearly removed after the failure.

The parent line materials processed in the busbar machine include copper, aluminum, steel, etc. Copper has a high conductivity, corrosion resistance, light aluminum and low price. When selecting the bus material, the technical policy of "replacing copper with couples" should be implemented. Except for the regulations, only the special environment of copper is allowed, and the aluminum bus should be used. Steel bus is used in places where the load current is small and the annual use is small.

CNC systems, PLC and servo drive systems all set up many modified parameters to meet the requirements of different machine tools and different working conditions. These parameters can not only match each electrical system with specific machine tools, but also make the function of the machine tools the best. Therefore, changes in any parameter (especially the simulation parameters) are not allowed to be lost; changes in mechanical or electrical performance caused by long -term operation of random tools will break the initial matching status and optimization state. Such failures refer to one type of failure in the first section of failure, and one or more parameters of the relevant relevant parameters need to be adjusted. This method is very high in requirements for maintenance personnel. It must not only understand the main parameters of the specific system, not only know the address of its address, but also have rich experience in electrical debugging. Multifunctional copper row manufacturer

Specific operation: This principle In the maintenance of the specific large -to -torque parent line machine, on the one hand, it is necessary to complete the peripheral components of the equipment before the equipment is disassembled, such as whether there is any defects, component damage outside the equipment, etc., and then the device is to put the equipment on the equipment. Disassemble for internal inspection. On the other hand, after the device is disassembled, the inspection of internal components must be found to check the sequence of parts from the outside to the inside. In short, when the large -to -torque parent line is maintained, you have to do it from the outside to the inside.